Maybe your ADT Impassa won’t close anymore or is missing the door now. ![]() The ADT Impassa Replacement door can really come in handy if your door or part of the base has broken. ![]() The ADT Security 804302 replacement battery is covered by our industry leading 1 year replacement warranty.Description of ADT Impassa Replacement door: Test your security system to make sure it is working properly, by following the instructions your system’s User’s Guide in the Testing the System section.Īfter testing your security system, close and lock the control panel and call the ADT Customer Care Department at 1-800-ADT-ASAP and request that the system be “removed from test” and normal monitoring be started back up.Īll Alarm Batteries from UPS Battery Center are new and always fresh stock. Connect the BLACK wire to the BLACK terminal of the new battery by pushing the connector firmly onto the terminal.Īfter you have connected the replacement battery to the security system, go to your alarm keypad to make sure that it no longer displays a “ BAT” or “ SYSTEM LO BAT” message. Next, locate the the BLACK colored positive (+) terminal on the top of the replacement battery. Connect the RED wire to the RED terminal of the new battery by pushing the connector firmly onto the terminal. Locate the the RED colored positive (+) terminal on the top of the replacement battery. Warning: Do not touch any metal objects to the terminals on the battery or to the open-end of the black and red wire connectors.įirst, place the new battery inside the control panel box and remove the plastic terminal protectors before connecting the wires to the battery. When the old battery is completely disconnected, remove it from the control panel box. Again, you may need to gently wiggle the connector to loosen and disconnect it, use electrical pliers with insulated handles. Next pull the RED wire’s connector from the positive (+) battery terminal. You may need to gently wiggle the connector to loosen and disconnect it, use electrical pliers with insulated handles. Pull the BLACK wire’s connector from the negative (-) battery terminal. Be extremely careful not to drop the battery to avoid the possibility of serious injury. Check that the battery doesn’t have cracks, fractures or leakage. Also make sure the battery wasn’t damaged during shipping. Rough handling may shock the battery, resulting in damage to the new battery. When unpacking the battery, make sure to handle it gently. Remove your new battery from the shipping box. ![]() Open the control panel box, either by removing the screws on the side of the cover or with the control panel key. When you find the battery locate the red and black wire terminals The control panel box is usually located inside a closet, basement or utility room in your home. The control panel battery is located inside your security system’s control panel box. Read the following directions on how to safely replace your system’s battery.Read the Battery Safety Warning information that comes with your new battery.Call the ADT Customer Care Department at 1-800-ADT-ASAP to have your security system placed “on test”.The ADT Safewatch Pro 3000 requires a 12V 5Ah replacement battery, model number 804302. The process requires the removal of two wires from the old battery and reconnecting them to the same posts on your new battery.Īt UPS Battery Center we stock a wide variety of batteries for all home security systems. You can replace the battery yourself, saving you time and money. However, if the warning remains on the display more than 24-48 hours after the power is restored, the battery needs to be replaced. When the power in the home is restored, the panel recharges the battery. If the power in your home goes out, the security system will shut down if the battery is below the operating level. When the keypad display on your ADT Safewatch Pro 3000 reads “ BAT” or “ SYSTEM LO BAT”, the emergency backup battery in the control panel is low and needs to be recharged or replaced.
0 Comments
Leave a Reply. |